Power Measurement And Control Instruments
Providing you the best range of 3 phase power clamp meter and inrush current measurement, 3 phase power clamp on meter, digital ac dc watt power clamp meter, gce make industrial manifold regulator mr60, multifunction power harmonics analyzer and multifunction power and harmonics analyzer with effective & timely delivery.
3 Phase Power Clamp Meter And Inrush Current Measurement
₹ 17600 Get Latest Price
| Model Number | 2745 |
| Display | 4 digit L.C.D with a maximum reading |
| Over range indication | (OL) or (- OL) is displayed |
| Jaw Opening Size | 46.5 mm |
| Measurement Rate | 1 times per second nominal |
| Battery Life | approx. 50 hours typical |
| Altitude | Upto 2000m |
| Model | 2745 |
| Sensing | True RMS Sensing |
| Power | Single 9 V Battery |
3 Phase Power Clamp On Meter
₹ 19300 Get Latest Price
| Model Number | 2709 |
| Ohm Function | 5.5 mA typical |
| Power Supply | Standard 1.5V AAA Battery x 2 |
| Low Battery | Below approx 2.4V |
| Sensing | True RMS sensing |
| APO Timing | Idle for 30 minutes |
| Polarity | Automatic |
| Power Consumption | Voltage,ACA,Hz & Power functions 11mA typical |
| Display Type | Digital |
| Altitude | Operating below 2000m |
- Selectable Power parameters of KW, KVAr & KVA with Total Power Factor in dual-display
- kWHr Recording
- AutoVA (Auto Selection on ACV, DCV or ACA functions)
- Total harmonic distortion THD% -F in dual-display
- Backlight display
- Display Hold
- PEAK-rms HOLD
- PC-Comm computer interface capabilities (optional)
Digital AC DC Watt Power Clamp Meter
₹ 10000 Get Latest Price
| Model Number | KM 2760 |
| Sampling Rate | 2.5 times / sec (Digital Display) |
| Pollution Degree | 2 |
| Polarity | Automatic polarity-display for negative input |
| Power Supply | 1.5V AA x 2 Alkaline battery |
| AC Sensing | Average Sensing |
| Auto Power Off | The meter powers off 15 minutes later after the last operating was made. |
| Jaw size | Cables f 40mm |
| Weight | approx. 400 g (Including Battery) |
| Dimension | 228(L) x 76(W) x 39(H) mm |
- Installation Categories III
- Indoor use only.
- Altitude up to 2000 meters
- 3-phase 3-wire & 4-wire
- Data Hold ? Auto Power off
Gce Make Industrial Manifold Regulator MR60
₹ 25000 Get Latest Price
| Type | Industrial Oxygen Regulator |
| Regulator Type | High Pressure Regulator |
| Outlet pressure range | 50 BAR |
| Material | Brass |
| Usage/Application | Industrial |
| Automation Grade | Automatic |
Minimum order quantity: 1 Piece
• Conforming to ISO 7291.
• High compressed gas service (O, D, N, CO , M, H) up to 600Nm3/h and up to 300 bar inlet pressure.
• 180°connectors for direct in-line mounting as manifold regulator.
• Integrated inlet filter ensures reliable function of the regulator even with old or dirty upstream pipeworks.
• Contains integrated pressure relief valve
• It can be used in many applications where is requested high-flow outlet with constant delivery pressure.
• Typical examples: Oxy-fuel cutting and other various oxy-fuel processes, laser process gas service, arc welding shielding gas pressure stabilizing, inertisation, etc.
INDUSTRIAL MANIFOLD REGULATOR
MR60
Multifunction Power Harmonics Analyzer
₹ 184000 Get Latest Price
| Brand | Kusam Meco |
| Model Number/Name | KM 2100 |
| Safety | CAT III 1000V / CAT IV 600V. |
| Electrical Safety Comply With | IEC61010-1 |
| Dimension | 262 x 173 x 66 mm |
| Flash Memory | 128MB |
| Weight | Approx. 1.6kg |
| IP | IP51, According IEC60529 |
| Standards | IEC61000-4-30 (2008) S class, EN50160 (2007). |
- Volts / Amps. / Hertz, Dips & Swell, Power / Energy, Unbalance, Monitor, Scope Harmonic, Logger & Interruption functions. (KM 2200)
- Inter Harmonics, Transient Voltage, Inrush Current, Flicker function not available in KM 2200.
- Frequency upto 400Hz (KM 2100); 50 / 60Hz (KM 2200)
- Single-phase 2W / Single-phase 3W / 3-phase 3W / 3-phase 4W.
- Flash memory 128MB
- TF Card 8G Memory Card for long-term measuring data storage
- Support USB port to connect to PC and analyze the data
- Support LAN port to make the remote control available, transfer the measuring data.
Multifunction Power And Harmonics Analyzer
₹ 156500 Get Latest Price
| Brand | Kusam Meco |
| Model Number/Name | KM 2200 |
| Standards | IEC61000-4-30 (2008) S class, EN50160 (2007). |
| Safety | CAT III 1000V / CAT IV 600V |
| IP | IP51, According IEC60529 |
| Weight | Approx. 1.6kg |
| Dimension | 262 x 173 x 66mm |
| Electrical Safety comply With | IEC61010-1 |
| Flash Memory | 128 MB |
- Volts / Amps. / Hertz, Dips & Swell, Power / Energy, Unbalance, Monitor, Scope Harmonic, Logger & Interruption functions. (KM 2200)
- Inter Harmonics, Transient Voltage, Inrush Current, Flicker function not available in KM 2200.
- Frequency upto 400Hz (KM 2100); 50 / 60Hz (KM 2200)
- Single-phase 2W / Single-phase 3W / 3-phase 3W / 3-phase 4W.
- Flash memory 128MB
- TF Card 8G Memory Card for long-term measuring data storage
- Support USB port to connect to PC and analyze the data
- Support LAN port to make the remote control available, transfer the measuring data.
Power Clamp Meters
₹ 17850 Get Latest Price
| Model Number | 2736 |
| Weight | Approx. 224 gm |
| Dimension | 224(L) x 78(W) x 40(H) mm |
| Ohm function | 5.5mA typical |
| Power Consumption | Voltage,ACA,Hz & Power 11mA typical |
| Power Supply | Standard 1.5V AAA Battery x 2 |
| Sensing | True RMS Sensing |
| Jaw Opening And Conductor Diameter | 45 mm max |
| APO Consumption | 4mA typical |
| APO Timing | Idle for 30 minutes |
**Key Features:**
- **Current Measurement**: Measures AC and/or DC current by clamping around a conductor, providing readings without the need to break the circuit.- **Voltage Measurement**: Measures AC and/or DC voltage across two points, essential for checking voltage levels in a system.- **Power and Energy Measurement**: Measures real power (watts), apparent power (volt-amperes), reactive power (volt-amperes reactive), and energy consumption (kilowatt-hours), providing detailed insight into electrical usage and efficiency.- **Digital Display**: Equipped with an LCD screen that displays readings clearly, often with backlighting for visibility in low-light conditions.- **Additional Functions**: May include features such as power factor measurement, harmonics analysis, and data logging for capturing and storing measurement data.- **Clamp Design**: Utilizes jaws or clamps that open to encircle a conductor, making it easy to measure current without interrupting the electrical circuit.
Power clamp meters are commonly used in electrical maintenance, troubleshooting, and energy audits, offering a comprehensive set of measurements to ensure efficient and safe operation of electrical systems.
Meco-g R-apfc 12 Automatic Power Factor Controller
₹ 5400 Get Latest Price
| Brand | MECO |
| Type | Industrial Relay |
| Digit Display Size | Digital |
| Packaging Type | Box |
| Shape | Rectangular |
| Country of Origin | Made in India |
Minimum order quantity: 2 Piece
Meco-g R-apfc 12 Intelligent Automatic Power Factor Controller
"MECO-G" Tap Position Transducers converts a resistance input to a standard DC output signal which is directly proportional to the input resistance. This DC output signal is Optically Isolated, Ripple Free and Stable. These accurate and reliable outputs are suitable for Telemetering, Data Loggers, PLC′s and SCADA systems
GENERAL SPECIFICATIONS
Resistance Input | Aux. Supply 24VDC, 48VDC, 110VDC, 220VDC, 110VAC, 230VAC (Any One) | |||
Potentiometric Resistance input from Upto 99 transformer taps 100 KΩ max | 0-230V AC ± 10% 50/60 Hz | 1.8VA APPROX | ||
OUTPUT | LOAD RESISTANCE | OUTPUT | LOAD RESISTANCE | |
0-1V | ≥1KΩ | 0-1mA | ≤1KΩ | |
TEMPERATURE TRANSDUCER
"MECO-G" Temperature Transducers converts a resistance input into a standard DC output signal which is directly proportional to the input resistance. This DC output signal is Optically Isolated, Ripple Free and Stable. These accurate and reliable outputs are suitable for Telemetering, Data Loggers, PLC′s and SCADA systems.
Input ( PT-100 Sensor) | Aux. Supply 24VDC, 48VDC, 110VDC, 220VDC, 110VAC, 230VAC (Any One) | |||
Resistive Input from PT-100 Sensor | 0-230V AC ± 10% 50/60 Hz | 1.8VA APPROX | ||
OUTPUT | LOAD RESISTANCE | OUTPUT | LOAD RESISTANCE | |
0-1V | ≥1KΩ | 0-1mA | ≤1KΩ | |
Power And Harmonics Analyzers
Product Videos
Contact Us
Anshul Pancholi (Director)
Air Equipments And Spares
Ground Floor, Shop No. 19, Dilkap Centre,Andheri, Kurla Road Andheri,East, Saki Naka, Mumbai - 400072, Maharashtra, India